It is currently Tue Oct 17, 2017 9:46 pm


220 Bay - Lean/Pulling to the right ?

Electronics, projects, motors, drives, props, drill some holes, etc.
  • Author
  • Message
Offline

Matt FL

Newbie

  • Posts: 8
  • Joined: Sat Jul 19, 2014 1:16 pm
  • nospam: no

220 Bay - Lean/Pulling to the right ?

PostSun Jul 20, 2014 3:26 pm

my 220 Bay seams to Pull to the right during the hole shot and stays that way until I Trim it out
and it "Mostly" comes out of it.

But if I trim her back down, You feel the boat start to drag and pull hard right.

2015 220 Bay w/ 175hp Suzuki

Thanks for the help
Offline

Seadweller

Intermediate member

  • Posts: 68
  • Joined: Wed Feb 23, 2011 4:45 pm
  • nospam: no

Re: 220 Bay - Lean/Pulling to the right ?

PostWed Jul 23, 2014 5:37 pm

Sounds like the trim tab on the outboard might need to be adjusted.
Offline

Matt FL

Newbie

  • Posts: 8
  • Joined: Sat Jul 19, 2014 1:16 pm
  • nospam: no

Re: 220 Bay - Lean/Pulling to the right ?

PostFri Jul 25, 2014 1:54 pm

Seadweller wrote:Sounds like the trim tab on the outboard might need to be adjusted.


Already tried that
Offline

Fuste1664

Newbie

  • Posts: 22
  • Joined: Sat Apr 05, 2014 10:31 am
  • Location: Sarasota FL
  • nospam: no

Re: 220 Bay - Lean/Pulling to the right ?

PostMon Jul 28, 2014 10:54 am

Remove the trim tab and see how it runs. If it still torques to the right it could possibly be a bent skeg.
Unless you have a tower or something that would cause wind drag?
Just a few thoughts.
Offline

Seadweller

Intermediate member

  • Posts: 68
  • Joined: Wed Feb 23, 2011 4:45 pm
  • nospam: no

Re: 220 Bay - Lean/Pulling to the right ?

PostMon Aug 04, 2014 4:18 pm

Also, check motor height...

Return to Technical Discussion, Fix it, improvements

Who is online

Users browsing this forum: No registered users and 1 guest

cron